14

2024

-

06

Precautions for backwashing filters

Author:


The selection of filter specifications should be matched with the installation pipeline, when the filter flow cannot meet the pipeline requirements, two (or more) filters can be installed in parallel, or do filter processing.

1. The selection of filter specifications should be matched with the installation pipeline, when the filter flow cannot meet the pipeline requirements, two (or more) filters can be installed in parallel, or do filter processing.

2. The filter should be installed in the place where the system is to be protected as far as possible, and the low pressure at the entrance affects the use, so it should also be installed near the pressure source.

3. The filter should be installed in series in the pipeline system. To ensure uninterrupted water supply when the system is shut down for maintenance, it is recommended that bypass be set in the system. Where backflow is likely to occur, a check valve should be installed at the filter outlet.

4. When selecting, pay attention to the water temperature flowing through the automatic self-cleaning filter does not exceed its adaptation temperature.

5. The installation site is equipped with three-phase 380V power frequency AC (three-phase four-wire system). The blowdown pipe should not exceed 5 meters to avoid back pressure.

6. Dc system pay attention to filtration accuracy, pretreatment, pressure matters, intermittent system pay attention to careful use of timing control type.

7. Choose the installation environment properly and pay attention to water, rain, and moisture.

Note: The backwash system stops running for a long time or stops running seasonally. Before the system stops running, add an appropriate amount of corrosion inhibitor in the water and take full water wet protection measures to reduce corrosion and protect the system.

The equipment has been debugged before leaving the factory, and users can run it directly when using it. When the operating parameters of the equipment cannot meet the requirements of the user, the user can adjust the parameters according to the actual working conditions, and choose the manual control and automatic control mode to work accordingly.

When running, the following steps should be followed:

1. Check whether the filter is in normal working condition:

2. Check whether the connections of the filter are firm.

3. Check that the electric control box of the filter should be dry.

4. Switch on the power supply, the green power indicator is on, and the electronic control part of the filter is in normal working condition, and the equipment can be put into trial operation.

Note: When plugging in the power supply, attention should be paid to keep the hand dry, while the filter should keep its electric controller part dry during the working process, no water can enter the electric controller inside.

SAF Coolest v1.3.1.2 设置面板FWVSX-AEVY-OSSQE-AFA

图片ALT信息: SoluGET

无数据提示

Sorry, the current column is being updated, please look forward to it!

You can view other columns or returnHome Page

V1.3.1 SVG图标库请自行添加图标,用div包起来,并命名使用

Submit
Action
Submit